Introduction

The installation program

You should be aware of the following procedures as you work in the installation program.

Making menu selections

To make a selection on the installation menus, use the Spacebar to insert an asterisk between the parenthesis. The asterisk indicates your selections.

The status line at the bottom of your screen indicates function key selections as follows:

<F1>: get help
<F2>: view parameter choices
<F10> and <Enter>: save your selections and continue
spacebar: toggle through selections and insert asterisks

Viewing system messages during installation

To view system messages during the installation you can use the System Logs Manager.

To access the System Logs Manager, perform either of the following steps whilest running in graphics mode:

Enter scoadmin at the command line. When the scoadmin window appears, select ``System'', then select the System Logs Manager.
Enter the following command:

scoadmin system logs manager

NOTE: When entering the name of a UnixWare manager on the command line, the manager name given as an argument to scoadmin is case-insensitive, so the following are equivalent:

scoadmin directory services install
scoadmin Directory Services Install

Exiting the installation

Permanent changes are made to your system only after you select ``Accept all settings and install now'' from the Installation Main Menu. If you want to make changes you can cycle through the menus again. If you want to exit completely, select ``Exit without installing'' on the Preinstallation Menu. No changes will be made to your system.